Black oxide phillips pan head type 10-32 X 5/8 in., fine thread, steel machine screw for use in relay racks. Bag of 25 screws. For reference, 10-32 is a #10 screw with 32 threads per inch. 10-32 Screws are used on most wall mount brackets, including all of ours, most Dell racks and audio racks.
Black oxide phillips pan head 12-24 X 5/8 in., coarse thread, steel machine screw for use in relay racks. Bag of 25 screws. For reference, 12-24 is a #12 screw with 24 threads per inch. 12-24 Screws are used for most dual post pre-threaded relay racks, also known as distribution racks.
These screws come in handy if the threads are stripped or the screw hole is cross-threaded. Use these screws to retap the hole.
Black oxide phillips type M6 metric steel machine screw for use in relay racks. Bag of 25 screws.M6 or 6MM screws and cage nuts are used on most HP and Compaq racks
12-24 X 3/4" Phil/Slot Combo Pan Head Steel Black Oxide, Bag of 25 (Screws for Vertical Wire Management Bracket)
This trim washer helps prevent scratches on rack components caused by over tightening mounting screws.Works with the following screw sets:
This cup washer works with our M6 screw part #HW155-60-M6-K.
10-32 cage nuts are used on most Dell racks and audio racks. These cage nuts snap into the industry standard 3/8" square holes found on racks and cabinets. Bag of 25 pieces.
M6, 6MM, cage nuts and screws are used on most HP and Compaq racks.These cage nuts snap into the industry standard 3/8" square holes found on racks and cabinets. Bag of 25 pieces.
This is a set of 50 screws per box.
This is a set of 110 screws per box.
This is a set of 370 screws per box.
Here is the breakdown:
3/4" 100 each
1" 75 each
1-1/4" 75 each
1-1/2" 50 each
2" 40 each
3" 30 each
The kit contains all of the hardware necessary to secure equipment rack to the concrete floor.For use with 19" or 23" racks.The kit includes: (4) 3/8" - 16 concrete anchors, (4) 3/8" - 16 x 3-1/2" studs, (4) 3/8" split washers, (4) 3/8" - 16 hex nuts, and 3/8" fender washers.
